Racelogic USER GUIDE Bedienungsanleitung PDF herunterladen (Seite 29)

RACELOGIC Traction Control Manual V3.0

Page 29

2. Software

2.1 Installation

To install the traction control software, insert the CD into your CD-ROM drive. After a

few seconds the “Install shield” prompt should appear. If the CD does not auto-run

then browse the CD and double-click the 'SETUP' icon to start the install process.

The install wizard will then guide you through the installation process.

2.2 Connecting the traction control to the computer

Connect a serial data cable from your computers COM port to the diagnostic lead of

the traction control.

Start the software and from the options menu select the COM port which you have

connected to the traction control via the serial lead.

Apply power to the traction control.

2.3 Transferring settings from the traction control

The supplied software allows you to adjust the settings which are stored within the

traction control. To discover what values are set inside your traction control, select

‘Read data’ from the options menu. The software will now communicate with the

traction control. If all is successful, a green bar will temporarily appear at the bottom

of the screen. All the values read from the unit will now be displayed in the software.

If the software failed to communicate with the traction control, a red bar will

temporarily appear at the bottom of the screen. Please check that you have selected

the correct COM port from the options menu, the traction control is powered up and

the serial lead still connected from your computer to your traction control unit.

Note: It is a good idea to save the values read from your traction control using the

‘save as’ option in the file menu in case you need to reset these values.

2.4 Transferring settings to the traction control

Once you have changed the settings in the software, you must write these values

into your traction control.

Ensure that ‘real time play’ is not enabled.

Select ‘Write data’ from the options menu. The software will now communicate with

the traction control. If all is successful, a green bar will temporarily appear at the

bottom of the screen. All the values are now written into the traction control unit.

If the software failed to communicate with the unit, a red bar will temporarily appear

at the bottom of the screen. Please check that you have selected the correct COM

port from the options menu, the traction control is powered up and the serial lead is

connected from your computer to your traction control unit.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 66 67

Keine Kommentare

Racelogic USER GUIDE Bedienungsanleitung Seite 29