Racelogic USER GUIDE Bedienungsanleitung PDF herunterladen (Seite 23)

RACELOGIC Traction Control Manual V3.0

Page 23

1.10 Launch Control

1.10.1 General

Launch Control is a method of controlling the revs at the start. It is activated by the

launch control button. This allows full throttle to be used, and the revs are controlled

by the traction control. This means you only have to balance one foot instead of two.

The system uses a secondary rev limit that removes itself automatically when the

rear wheels are within a set percentage slip of the front wheels.

The Launch Control rev-limits can be programmed using two methods depending

upon whether you have access to a laptop computer.

The Launch Control has two different rev-limits that can be set, WET and DRY. The

wet rev-limit only works when the switch is positioned in the WET position. All other

settings on the switch use the DRY launch.

1.10.2 Adjuster Program

The Launch control rev-limits can be programmed using the launch button supplied

as part of the Traction Control Switch. Follow the procedure below to program in Wet

or Dry rev-limits.

• Turn the vehicles ignition OFF.

• Turn the adjuster to wet or dry settings depending upon which rev-limit you wish

to program.

• Turn the vehicles ignition ON and start the vehicle.

• Press the launch button once.

• Press the launch button again and hold down the launch button.

• Rev the engine to the desired Launch rev-limit.

• Release the launch button.

• The rev-limit will be set.

NOTE - When using the launch button to calibrate, the soft cut is set when the button

is released, and the hard cut 250 RPM higher.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 66 67

Keine Kommentare

Racelogic USER GUIDE Bedienungsanleitung Seite 23